Swisher ZT18542 M Manuel d'utilisateur

REPAIR MANUALZT18542ZT2350Swisher Mower CoWarrensburg, MO

WIRE IDENTIFICATION ON ZT18542Gray wire goes to ignition switchBlack wire goes to ignition switchRed wire goes to terminal on solenoid with the positi

WIRING HARNESS TO ENGINE PLUG CONNECTIONGray wire goes to carburetor fuel solenoidGreen wire goes to oil pressure switchBlack wire goes to engine igni

CARBURETOR FUEL SOLENOIDUSED ON ZT2350Black wire goes to engine ground.Gray wire goes to the engine plug, then on to the ignition switch where it rece

BATTERY CHARGING SYSTEMSTo test alternator before it goes to the regulator, unplug the yellow connector and measure the AC voltage across the the two

ADJUSTING THE DRIVE CONTROLSRemove left and right instrument covers for accessOnce the tracking adjustments have been made on the previous page, the h

TRACKING ADJUSTMENTSAdjustments to the unit may need to be made if the unit does not track in a straight line. The primary reason for the unit not tr

REPLACEMENT OF THE HYDRO UNIT Prepare to replace the unit by jacking the mower up on the side where the defective unit is located. Use a jack stand to

REPAIRING OR REPLACING BLADE DRIVER Torque top nut to 90 ft/lbs Replacing this nut each time is recommended.Pulley does not have a hub. When removing,

BELT REPLACEMENT ROUTING•Clutch drive belt replacement•Remove belt covers•Disconnect tension idler from tension bracket•Remove belt from mower pulley

REPLACEMENT PARTSQuick ReferenceSwisher Part# Description•66LR Hydro belt•3752 Deck belt for 42”•3816 Deck belt for 50”•9004 and 9005 Blades for 42”

For additional assistance on service Contact Swisher Mower Co., Inc.Phone 1-800-222-8183Fax 1-660-747-8650E-mail [email protected] manual w

REPAIRMANUALMODEL NO.ZT2350Each mower has its own model number. Each engine has its own model number. The model number for the mower will be found u

TABLE OF CONTENTS1. If engine won’t crank2. If engine won’t crank - continuedBattery ground connection at engine3. Engine cranks but won’t startEngine

IF ENGINE WON’T CRANKALWAYS CHECK FUSE FIRSTTEST #1Using a remote starter switch or a suitable device, make a connection between the large terminals

2 A neutral switch is located at the lower end of both drive control handles and is activated when the handles are outward in the neutral position. Ch

ENGINE CRANKS BUT WON’T STARTChecks for electrical problems•While turning ignition switch to its first position, listen for the fuel solenoid on the c

IF PTO CLUTCH WILL NOT ENGAGEApply a negative ground to this terminalApply 12Volts to this terminal. Clutch should activate, if it doesn’t, clutch is

WIRING DIAGRAMHOUR METER USED ONLY ON ZT2350HOUR METER NOT OPERATINGHour meter has a positive and a negative post. Gray wire should go on the positive

WIRE IDENTIFICATION AT SWITCHES3623 IGNITION SWITCH One gray wire goes to the PTO switch and the other goes to the hour meterOne black wire goes to PT